Differences

This shows you the differences between two versions of the page.

--- sensors:tiltmeter [2012/09/11 14:50]
karina [Operating Characteristics]
+++ sensors:tiltmeter [2013/10/21 13:58]
claes [Software]
@@ Line 10: / Line 10: @@
 |User manual| {{:sensors:tcm_user_manual_r05.pdf|Download}}|
 |Data sheet|{{:sensors:tcmxbandmb_datasheet.pdf|Download}} |
+===== Software =====
+{{:sensors:tcm_studio_ver_3_0.msi|TCM Studio 3.0}}
+{{:sensors:tcmtest.zip|}}
 ===== Links =====
@@ Line 45: / Line 50: @@
 | ::: ||Repeatability||± 0.1 μT|
-(1*) Specifications are subject to change. Assumes the TCM is motionless and the local magnetic field is clean relative to the calibration.
+(1*) Specifications are subject to change. Assumes the TCM is motionless and the local magnetic field is clean relative to the calibration. \\
-(2*) For example, if the calibration was performed over ±10° of tilt, then the TCM would provide <2° rms accuracy over ±20° of tilt.
+(2*) For example, if the calibration was performed over ±10° of tilt, then the TCM would provide <2° rms accuracy over ±20° of tilt.\\
 (3*) Performance at maximum operational dip angle will be somewhat degraded.
 ==== Operating Characteristics ====
+=== I/O Characteristics ===
 ^Parameter^^Value^
 |Communication Interface|TCM XB|Binary RS232 UART|
@@ Line 59: / Line 67: @@
-(1*) The maximum sample rate is dependent on the strength of the magnetic field, and typically will be from 25 to 32 samples/sec.
+(1*) The maximum sample rate is dependent on the strength of the magnetic field, and typically will be from 25 to 32 samples/sec.\\
 (2*) FIR taps set to "0".
+=== Power Requirements ===
+^Parameter^^^Value^
+|Supply Voltage|TCM XB||3.6 to 5 VDC (unregulated)|
+|:::|TCM MB||3.3 to 5 VDC (unregulated)|
+|Average Current Draw|TCM XB|@ max. sample rate|20 mA typical|
+|:::|:::|@ 8 Hz sample rate|16 mA typical|
+|:::|TCM MB|@ max. sample rate|17 mA typical|
+|:::| ::: |@ 8 Hz sample rate|13 mA typical|
+|Peak Current Draw|During application of external power||120 mA pk, 60 mA avg over 2 ms|
+|:::|During logical power up/down or Sync Trigger||100 mA pk, 60 mA avg over 4 ms|
+|Sleep Mode Current Draw|||0.3 mA typical|
+=== Environmental Requirements ===
+^Parameter^Value^
+|Operating Temperature (1*)|-40C to +85C|
+|Storage Temperature|-40C to +85C|
+(1*) To meet performance specifications, recalibration may be necessary as temperature varies.
+===== TCM Pin Descriptions =====
+^Pin number^   TCM XB    ^^
+^:::^9 pin connector^Pigtailed cable wire color^
+|1|GND|Black|
+|2|GND|Grey|
+|3|GND|Green|
+|4|NC|Orange|
+|5|NC|Violet|
+|6|NC|Brown|
+|7|UART Tx|Yellow|
+|8|UART Rx|Blue|
+|9|+5 VDC|Red|

Technology in Crop Production

User Tools

Site Tools

Differences

Page Tools