This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
robots:status [2014/09/19 17:52] david [Talos] |
robots:status [2021/08/14 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Status of the robots ====== | ====== Status of the robots ====== | ||
- | ===== The Hako/AMS - Autonomous Mechanisation System | + | ===== The Hako ===== |
Operational 95 % | Operational 95 % | ||
Line 10: | Line 10: | ||
<note tip> | <note tip> | ||
<note important> | <note important> | ||
- | |||
- | |||
- | |||
- | **Todo** | ||
- | |||
- | - Build a attachmend for computer | ||
- | - Check obstacle avoidance for motorcontrollers | ||
- | - Build chassis for Touchpad | ||
- | - Get a cable from VGA to 5 pole | ||
- | - Get the robot waterproof | ||
- | |||
- | **Done** | ||
- | * Build cable canal in the middle | ||
- | * Change acceleration and deceleration of the motorcontrollers in mobotware (the left is different from the right one) | ||
Line 30: | Line 16: | ||
< | < | ||
- | |||
- | **Todo** | ||
- | |||
- | - Implement second laserscanner | ||
- | - Change wires and circuit | ||
- | - Get new wheels | ||
- | - Get new Motors 12V and min 1N/m per Motor | ||
- | - Build chassis for Touchdisplay | ||
- | - Make it water and dirt resitant | ||
- | - Implement Kinnect navigation | ||
- | | ||
- | |||
- | **Done** | ||
- | |||
- | -start conception of wheel suspension | ||
Line 51: | Line 22: | ||
No. 4 is not complete; | No. 4 is not complete; | ||
- | The rest are used right now by students | ||
- | **Todo** | + | |
- | check | + | |
- | - nothing at the moment | + |