This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
sensors:lsm111 [2012/09/10 16:11] karina [Electrical data] |
sensors:lsm111 [2021/08/14 04:21] (current) |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| LMS 1XX | LMS 1XX | ||
| {{: | {{: | ||
| + | |||
| + | LMS 1XX | ||
| + | {{: | ||
| {{: | {{: | ||
| + | |||
| + | SOPAS | ||
| + | {{: | ||
| ====== Specifications ====== | ====== Specifications ====== | ||
| Line 154: | Line 160: | ||
| |- Type|Two-channel rotary encoder with 90° phase offset||| | |- Type|Two-channel rotary encoder with 90° phase offset||| | ||
| |- Enclosure rating|IP 54| | | | |- Enclosure rating|IP 54| | | | ||
| - | |- Supply voltage|Uv – 3 V| |Uv| | + | |- Supply voltage|U< |
| |- Outputs required on the incremental encoders|Push&/ | |- Outputs required on the incremental encoders|Push&/ | ||
| |- Pulse frequency| | |100 kHz| | |- Pulse frequency| | |100 kHz| | ||
| Line 162: | Line 168: | ||
| |- Number|3||| | |- Number|3||| | ||
| |- Voltage drop load| |2 V| | | |- Voltage drop load| |2 V| | | ||
| - | ||||| | + | |- Maximum switching current| | |140 mA| |
| - | ||||| | + | |- Current limiting (after 5 ms at 25°C (77 °F)|100 mA| |200 mA| |
| - | ||||| | + | |- Power-up delay|Negligible||| |
| - | ||||| | + | |- Switch off time| |0.8 ms|2 ms| |
| - | ||||| | + | |**Relay switching outputs** LMS122/123|||| |
| - | ||||| | + | |- Number|2||| |
| - | ||||| | + | |- Switching capacity| | |DC 30 W/ AC 37,5 VA| |
| - | ||||| | + | |- Switching voltage| | |DC 110 V/ AC 125 V| |
| - | ||||| | + | |- Switching current| | |0.5 A at DC 30 V| |
| - | ||||| | + | |- Switching capacity| | |10μA DC 10 mV| |
| + | |- Switching cycles|10< | ||
| + | |- Power-up delay| |2 ms|4 ms| | ||
| + | |- Switch off time| |2 ms|4 ms| | ||
| + | |**Serial auxiliary interface**|||| | ||
| + | |- Communication protocol|RSH232 (proprietary)||| | ||
| + | |- Transmission speed|9,600 Baud|57.6 kBd|115.2 kBd| | ||
| + | |**Serial host interface**|||| | ||
| + | |- Communication protocol|RSH232 (proprietary)||| | ||
| + | |- Transmission speed (selectable)|9, | ||
| + | |- Cable length at 38.400 kBd and wire cross- section 0.25 mm2 (approx. 24 AWG)| | |15 m (49.21 ft)| | ||
| + | |- Galvanic de-coupling|Yes||| | ||
| + | |- Wire cross-section of the connecting cable| | |0.25 mm2 (approx. 24 AWG)| | ||
| + | |Ethernet|10/ | ||
| + | |CAN|20 kBit/s, 500 kBit/s, 1 Mbit/s||| | ||
| ===== (1*)(2*)(3*) ===== | ===== (1*)(2*)(3*) ===== | ||