This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
robots:armadillo:hardware:motors [2012/02/03 18:39] claes |
robots:armadillo:hardware:motors [2021/08/14 04:21] (current) |
||
---|---|---|---|
Line 3: | Line 3: | ||
- | ====== Motorcontrollers ====== | ||
- | The motorcontrollers are two [[http:// | ||
- | Here is an overview of the technology RoboteQ is using: [[robots: | ||
- | |||
- | * Datasheet | ||
- | * Usermanual | ||
- | * Controlsoftware | ||
- | |||
- | ^ Table with alignment VBL1650 | ||
- | ^ **Power Stage** | ||
- | |Operating Voltage| | ||
- | |Number of Channels| | ||
- | |Max Current| | ||
- | |::: | ||
- | |::: | ||
- | |Surge Current| | ||
- | |ON Resistance| | ||
- | |Current Limiting|By automatic power output reduction above user preset level, per channel.|| | ||
- | |Synchronous Rectification|Yes - Allows regenerative braking.|| | ||
- | |Temperature protection |Automated current limit reduction starting at 70o C (175o F) heat sink temperature.|| | ||
- | |Voltage protection|Output shut off below 9V and above 50V - user adjustable|| | ||
- | |Short Circuit protection| | ||
- | |Power Wiring | AWG8 Cables | ||
- | | **Command** | ||
- | |R/C Inputs| | ||
- | |Serial Interface| | ||
- | |Analog Interface| | ||
- | |Input Corrections|Programmable deadband. 6 Exponent & Logarithmic command curves.|| | ||
- | | **Input/ | ||
- | |Optical Encoder Interface| | ||
- | |Hall Sensor Inputs|3 phase inputs for motor switching, speed capture and odometry.|| | ||
- | |Analog Inputs| Up to 4 inputs, 10-bit resolution. || | ||
- | |Digital Outputs| | ||
- | |Digital Inputs| Up to 6 general purpose inputs.|| | ||
- | |Pulse Inputs| Up to 5 Pulse Length, Duty Cycle or Frequency inputs.|| | ||
- | |5V Supply Output| | ||
- | ^ Operating Modes ^^^ | ||
- | |Open Loop Speed| Forward & Reverse Speed Control. Separate or Mixed. || | ||
- | |Closed Loop Speed| Use Hall Sensors, analog or pulse speed feedback. PID. || | ||
- | |Position Mode | Use Hall Sensors, analog or pulse position feedback. PID. || | ||
- | ^ MicroBasic Scritping | ||
- | |Max Program Size| ~1500 lines of Basic-language code, 1000 user variables. || | ||
- | |Execution Speed| Higher than 50,000 lines per sec. || | ||
- | ^ Physical | ||
- | |Operating Temperature | -40 to +85oC heat sink temperature | ||
- | |Enclosure | Aluminum extrusion | ||
- | |Cooling | Heatsink | ||
- | |Controller size | 5.5" (140mm) wide x 1.6" (40mm) tall x 9" (228mm) long including mounting brackets. || | ||
- | |Cables | 10" (25cm) RC cable to Radio || | ||
- | |Weight | 3.3lbs (1.5kg) |